Brand New MSD Crank Trigger Kit, Red, Flying Magnet, Hall Effect, 6.562" Diameter, Compatible with Small Block Сhevrolet Gen III/IV Engines (Part #8618).
Upgrading to an MSD Flying Magnet Crank Trigger Kit will deliver the precise and reliable signal that a high-performance engine requires. This kit gives you the ability to control timing electronically through a Holley ЕFI ЕCU (or other standalone engine management system/ignition controller).
At the heart of the kit is the 3-wire Hall-Effect Sensor that is easier to set up, less susceptible to EMI/RFI interference/noise, and less likely to have false signals than other methods. They are less prone to mechanical failure since there are no wear parts. With the included high-quality timing pointer & use of a direct bolt-on, degreed balancer (ATI 917776 or 917215), you will be able to adjust timing in the precise increments required for your LS Engine.
Features: Most accurate way to trigger your electronic fuel injection (ЕFI) | Powerful magnets embedded in a 3/8" thick billet 6061-T6 aluminum trigger wheel | 3-wire Hall-Effect Sensor that is not easily susceptible to EMI/RFI Interference | Allows precise indexing by utilizing the 10 degree range on included timing pointer | Easy to install much like traditional MSD Crank Trigger Kits (use with ATI Balancer - 917776 or 917215) | Rigid mounting that will not flex & cause timing fluctuation
NOTE: On some vehicles the MSD Crank Trigger Kit may require slight modifications to accommodate special engine plates, pulley systems, etc. | NOTE: Designed to be used with the ATI Harmonic Balancer 917776 or 917215. Also compatible with Meziere water pump WP333 & LSX Blocks.
